The Problem

Tamper EB 102-20 and isolated from moisture by sealing it from all sides with all the same heat-shrinkable tubing. Also, before sealing is recommended to replace thin wire type KSPV staff of Intrusion IO 102-20 on wire PRPPM 2×0, 9 (without opening the reed switch!), that is, the wire of the same brand that is laid on communication in the organization of the plume. The junction of the wires with reed wrapped with electrical tape and put into a cavity in the sensor housing so that the wire coming out of the body PRPPM. For the primary mechanical fastening wires PRPPM at his place of entry into the sensor body can use the same tape. Plays an important role in the partition of the wells Tester TV-01.

It was created as a tool for automated diagnostic cables signaling. Previously, users were extremely difficult to determine what specifically defective in the line. Troubleshooting has been complicated by the specifics of the installation site and subsystems. Professionals of our service and tech support was difficult to understand what causes malfunctioning subsystems, when user to handle the problem. Out of the situation at times there was only one – check out the object with an oscilloscope and detailed diagnosis USI96K and its attached cables. It took time, as the user and the developer. Not to mention the impossibility of an immediate response to requests of users with such problems in other cities. Tester also allows the user to determine fault, indicating the specific location where required intervention.